Tikkurila Intact Interior wood paint

Intact wood paint can be applied to a wide range of interior surfaces, and dries to an flat 8% matt or a 40% satin finish which is hard wearing and easily cleaned. Intact will resist cleaning detergents and weak solvents.
It is suitable for application to interior wood, paneling, doors, furniture, walls and MDF. 

Surface Preparation. 
Surfaces must be clean, dry, and free from grease, dirt, oil, wax, rust, loose material and surface contamination. Use Tikkurila cleaning and mould removal products for best results. 
Treat knots and resinous areas with Tikkurila Knotting Lacquer and a good quality filler for filling cracks, nail holes, blemishes and levelling of uneven surfaces. 
Ensure painted and filled surfaces are thoroughly sanded smooth.

Note: Discoloration of paint, especially noticeable within light colours, may occur over knots and resinous areas present in the wood. Particular attention with regards to preparation should be given to wood such as Oak, Teak, Cedar, Douglas Fir, Mahogany and Idigbo, etc., which contain oil and water-soluble tannin which may impair the drying, hardening or adhesion of surface coatings and discolour the finished surface.
Prime bare interior wood overall and, if necessary, spot prime all bare areas on previously painted surfaces with Intact Primer or Otex Adhesion Primer
Otex Adhesion Primer is also recommended for wood that contains substances which may ‘bleed through’ and cause staining to the finished surface.
Prime all bare metal and potential rust spots with Rostex Super.

Application and Thinning
Methods: brush, roller or spray application. Polyester or nylon paint brushes are best suited for the application of Intact.
For airless spray: use a 0.013” – 0.015” spray tip.
Thinning: if necessary thin by up to 5% with water.

Please read the Product Datasheet prior to commencing application.